SPARE TIRE SAVER
STANDARD SERIES - BLACK MAX SERIES
SPARE TIRE THEFT PROTECTION
|STEP ONE Lower spare tire for access to the winch mechanism and frame cross-member. The stamped 1-1/8" dia. hole approx. six inches from left side of the winch mechanism is used to install the U-bracket. Position the U-bracket as shown in below left picture. Install the U-bracket using the provided 3/8" X 3/4" bolt, locknut and two flat washers. Place one washer over the stamped hole from the top side of the cross-member and the second washer between the cross-member and the U-bracket.|
Install the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the left side frame rail. Install the crimp-ring retainer in the groove and crimp closed with pliers.
STEP THREE Raise the spare tire while guiding the lower end of lock bar through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as spare tire is returned to the full up/stored position.
STANDARD SERIES LOCKING INSTRUCTIONS:
The PVC bar cover/seal is designed to center and hold the lock against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.|
BLACK MAX SERIES LOCKING INSTRUCTIONS: (1) Remove the key from the lock cylinder.(2) Place the Black Max lock assembly over the end of the lock bar with the bar cover/seal end up. (3)Slide the lock assembly upward until the cover/seal makes contact with the tapered surface of the lug hole. (4)Press in on the "Push To Lock" button with the lock assembly still against the surface of the wheel, to engage the deadbolt lock mechanism with the groove in the locking bar.
Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants