Make your own free website on Tripod.com

WINCHLOCK
SPARE TIRE SAVER
STANDARD SERIES - BLACK MAX SERIES

SPARE TIRE THEFT PROTECTION

TOYOTA LANDCRUISER
1997-Up

LEXUS LX470
1998-Up

INSTALLATION INSTRUCTIONS


STEP ONE Lower the spare tire for access to the winch mechanism and frame cross-member. Note that the winch mechanism is mounted inside the C-channel frame cross-member. A 3/8" mounting hole must be drilled in the crossmember to install the mounting bracket.


STEP TWO Place a piece of masking tape over the inside surface of the frame cross-member and mark the location of the mounting hole as shown.The center of the mounting hole is located one inch from the left rear inside edge of the cross-member and down 2-9/16 inches from the edge of the winch mechanism. Using a power drill and eye protection, drill the 3/8 inch mounting hole to attach the bracket to the frame cross-member.


STEP THREE Use the provided 3/8" bolt, lock nut and two flat washers to attach the U-bracket to the frame cross-member. Position the U-bracket with the upper left corner against the inside edge of the cross-member.

Place the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the rear of the vehicle. Place the crimp-ring retainer in the groove and crimp closed with pliers. The distance between the winch cable and the lock bar should be 3-1/8" if the bracket is positioned correctly. Rotate bracket to adjust for proper distance, as needed.

STEP FOUR Raise the spare tire allowing the lower end of lock bar to pass through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The locking bar must remain vertical as spare tire is returned to the full up/stored position.

This Lock Is Designed To Install With The Spare Tire In The Original Factory Position,Valve Stem Up.

STANDARD SERIES LOCKING INSTRUCTIONS: The PVC bar cover/seal is designed to center and hold the lock against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.

BLACK MAX SERIES LOCKING INSTRUCTIONS: (1) Remove the key from the lock cylinder.(2) Place the Black Max lock assembly over the end of the lock bar with the bar cover/seal end up. (3)Slide the lock assembly upward until the cover/seal makes contact with the tapered surface of the lug hole. (4)Press in on the "Push To Lock" button with the lock assembly still against the surface of the wheel, to engage the deadbolt lock mechanism with the groove in the locking bar.


RECORD KEY CODE NUMBER FOR FUTURE REFERENCE



Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants


UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back||Main Page||email||Order Form

800/843-5701
www.motivelocks.com