SPARE TIRE SAVER
STANDARD SERIES - BLACK MAX SERIES
SPARE TIRE THEFT PROTECTION
Lower spare tire for access to the winch mechanism attached to the lower side of the frame cross-member with four flange type mounting bolts. Locate and remove the mounting bolt on the left side of the winch mechanism. Install U-bracket using the existing mounting bolt. Position the U-bracket as pictured and tighten the mounting bolt.
Install the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the rear of the vehicle. Place the crimp-ring retainer in the groove and crimp closed with pliers.
Raise the spare tire while guiding the lower end of lock bar through lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as the spare tire is raised to the full up/stored position.
STANDARD SERIES LOCKING INSTRUCTIONS: The PVC bar cover/seal is designed to center and hold the lock against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.
Back||Main Page||email||Order Form