Make your own free website on Tripod.com

WinchLock
STANDARD SERIES - HIGH SECURITY

SPARE TIRE THEFT PROTECTION

NISSAN

TITAN PICKUP / ARMADA SUV
2004-UP

INSTALLATION INSTRUCTIONS


STEP ONE Lower spare tire for access to the frame cross-member and winch mechanism. Locate the pointed end of the wiring harnass retainer clip extending through the small stamped hole in the cross-member, just to the left of the winch mechanism. Use pliers to squeeze the pointed tip of the retainer clip and push it through the hole.

STEP TWO Use the provided 5/16" x 3/4" bolt, two flat washers and locknut to attach the U-bracket to the cross- member. The bolt with a flat washer is placed through the U-bracket. The locknut and second flat washer install on the back side of the cross-member. Position the U-bracket, as shown and tighten the locknut. Install the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the winch mechanism. Place the crimp-ring retainer in the groove and crimp closed with pliers.

STEP THREE Raise the spare tire while guiding the lower end of the lock bar down through the lug hole least obstructed by the tire mounting plate attached to the winch chain.

This Lock Is Designed To Install With Spare Tire In The Factory Installed Position, Valve Stem Up.

STEP FOUR The PVC lock bar cover/seal is designed to center and hold the lock firmly against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.

RECORD KEY CODE NUMBER FOR FUTURE REFERENCE


Lubricate Grease Fitting Once A Year To Validate Limited Lifetime Corrosion Warranty
DO NOT Use Lithium Base Lubricants


UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back| |Main Page

800/843-5701

www.motivelocks.com