Make your own free website on Tripod.com

WinchLock II
STANDARD SERIES - HIGH SECURITY

SPARE TIRE THEFT PROTECTION

DODGE

DAKOTA PICKUP
2005-UP

INSTALLATION INSTRUCTIONS


STEP ONE Lower spare tire for access to frame cross-member panel with winch mechanism mounted above. Locate the 5/8" diameter hole stamped in the panel several inches rearward of the winch mounting bolt as shown in picture at left.

Install the U-shaped mounting bracket and position as shown in picture at right using the provided 3/8" bolt, lock nut and flat washers.


STEP TWO Install the lock bar through the holes in both legs of the U-bracket, with the grooved end toward the rear corner of the right side frame rail. Place the crimp-ring retainer in the groove and crimp closed with pliers.

STEP THREE Raise spare tire while guiding the lower end of lock bar through lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as the spare tire is raised to the full up/stored position.

This Lock Is Designed To Install With The Spare Tire In The Original Factory Position, Valve Stem Down.

STEP FOUR The PVC bar cover/seal is designed to center and hold the lock firmly against the tapered surface of the lug hole. Hold lock inverted with the PVC cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.


RECORD KEY CODE NUMBER FOR FUTURE REFERENCE


Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants


UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back||Main Page

800/843-5701

www.motivelocks.com