STANDARD SERIES - HIGH SECURITY
SPARE TIRE THEFT PROTECTION
Lower spare tire for access to the winch cable tube and mounting bracket assembly attached to the frame cross-member directly above. Locate the stamped hole in the cross-member, in front of the mounting bracket assembly.
Place the U-bracket over the stamped hole, aligned with the edge of the frame cross-member, as shown in picture. Attach U-bracket to the frame using the provided washers, bolt and locknut. Install with one washer under bolt head and other under the locknut.
Install the lock bar through both legs of the U-bracket, with the grooved end facing toward the right rear side of the vehicle. Install the crimp-ring retainer in the groove and crimp closed with pliers.
Slowly raise the spare tire, allowing the lower end of the lock bar to pass through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as the spare tire is returned to the full up / stored position.
This Lock Is Designed To Install With The Spare Tire In The Orignal Factory Position, Valve Stem Up.
The PVC lock bar cover/seal is designed to center and hold the lock firmly against the tapered surface of the lug hole. Hold lock inverted with the PVC bar cover/seal end up. Place lock over the end of the lock bar. Slide lock upward against the tapered surface of the lug hole and rotate to engage lock mechanism with the lock bar groove.
RECORD KEY CODE NUMBER FOR FUTURE REFERENCE
Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants
UNITED STATES PATENTS
4794771 - D399122 - 6505488
Back| |Main Page