Make your own free website on Tripod.com

WinchLock II
BLACK MAX SERIES - MAXIMUM SECURITY

SPARE TIRE THEFT PROTECTION

ISUZA

ASCENDER
2003-Up

INSTALLATION INSTRUCTIONS

STEP ONE
Lower spare tire for access to the winch cable tube and mounting bracket assembly attached to the frame cross-member directly above. Locate the stamped hole in the cross-member, in front of the mounting bracket assembly.

STEP TWO
Place the U-bracket under the stamped hole and align with the edge of the frame cross-member, as shown. Attach U-bracket to the frame using the provided washers, bolt and locknut. Install with one washer under bolt head and other under the locknut.

STEP THREE
Install the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the right rear of the vehicle. Place the crimp-ring retainer in the groove and crimp closed with pliers.

STEP FOUR
Slowly raise the spare tire, allowing the lower end of the lock bar to pass through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as the spare tire is returned to the full up / stored position.

This Lock Is Designed To Install With The Spare Tire In The Orignal Factory Position, Valve Stem Up.

SPECIAL BLACK MAX LOCKING INSTRUCTIONS:
(1) Remove key the from the lock cylinder. (2)Place the Black Max lock assembly over the end of the locking bar with the bar cover/seal end up. (3)Slide the lock assembly upward so that the cover/seal is compressed in the tapered surface of the lug hole. (4)Press in on the "Push To Lock" button with the lock assembly still held firmly against the tapered surface to engage the deadbolt lock mechanism with the groove in the locking bar.

RECORD KEY CODE NUMBER FOR FUTURE REFERENCE


Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants

UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back| |Main Page

800/843-5701
www.motivelocks.com