SPARE TIRE THEFT PROTECTION
BLACK MAX SERIES - MAXIMUM SECURITY
Tahoe/Suburban/Avalanche - Yukon/XL - Escallade/ESV
Lower spare tire for access to winch mechanism and frame member directly above. Locate the stamped round hole in the frame cross-member panel approx. six inches diagonally to the rear of the winch mechanism.
Reaching over the top side of the frame cross-member, install the provided 3/8” bolt and flat washer down through the stamped hole. Place the U-bracket over the threaded end of the bolt using the locknut and second flat washer to secure the bracket. Install the U-bracket as shown, with the holes in both legs facing toward the winch cable and tighten the locknut.
Install the lock bar through the holes in both legs of the bracket, with the grooved end facing away from the winch cable. Place the crimp-ring retainer in the groove and crimp closed with pliers.
Raise the spare tire while guiding the lower end of lock bar through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as spare tire is returned to the full up/stored position.
This lock is designed to install with the spare tire in the original factory position, valve stem up.
SPECIAL BLACK MAX INSTALLATION INSTRUCTIONS:
(1)Remove the key from the lock cylinder. (2)Place the Black Max lock assembly over the end of the locking bar with the bar cover/seal end up. (3)Slide the lock assembly upward until the bar cover/seal is compressed in the tapered surface of the lug hole. (4)
Press in on the "Push To Lock" button with the lock assembly still held firmly against the wheel, to engage the dead bolt lock mechanism with the groove in the locking bar.
RECORD KEY CODE NUMBER FOR FUTURE REFERENCE
Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants
UNITED STATES PATENTS
4794771 - D399122 - 6505488
Back| |Main Page