Make your own free website on Tripod.com
WinchLock II
BLACK MAX SERIES - MAXIMUM SECURITY
SPARE TIRE THEFT PROTECTION

CHEVROLET-GMC

SILVERADO PICKUPS / SIERRA PICKUPS
1999-2002

INSTALLATION INSTRUCTIONS


SIX WAYS TO DEFEAT THE PLASTIC CHEV/GMC FACTORY SPARE TIRE LOCK


STEP ONE
Lower spare tire for access to winch mechanism and the frame cross- member directly above. Locate and remove the single winch mechanism mounting bolt, using a 15mm open end wrench or flex-socket.

NOTE: The weight of the suspended spare tire must be supported or the mounting flange of the winch mechanism temporarily clamped to frame rear cross-member before removing the single mounting bolt.

STEP TWO
Place the existing winch mechanism mounting bolt through the 3/8 center hole of U-bracket and reinstall the winch mechanism to the frame cross-member. The open side of U-bracket should align with forward edge of winch mechanism mounting flange and parallel to the outer wall of the plastic winch tube as shown in the picture.

STEP THREE
Install the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the left side frame rail. Place the crimp-ring retainer in the groove and crimp closed with pliers.

STEP FOUR
Raise the spare tire while guiding the lower end of the lock bar through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as the spare tire is returned to the full up/stored position.

This lock is designed to install with the spare tire in the original factory position, valve stem down.

SPECIAL BLACK MAX LOCKING INSTRUCTIONS:
(1)Remove the key from the lock cylinder. (2) Place the Black Max lock assembly over the end of the of the locking bar with the bar cover/seal end up. (3)Slide the lock assembly upward so that the bar cover/seal is compressed in the tapered surface of the lug hole. (4) Press in on the "Push To Lock" button with the lock assembly still held firmly against the wheel to engage the deadbolt lock mechanism with the locking bar.


RECORD KEY CODE NUMBER FOR FUTURE REFERENCE


Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants


UNITED STATES PATENTS
4794771 - D399122 - 6505488

Back| |Main Page

800/843-5701

www.motivelocks.com