BLACK MAX SERIES - MAXIMUM SECURITY
SPARE TIRE THEFT PROTECTION
EXPLORER SPORT TRAC
Lower spare tire for access to the winch mechanism mounted above the frame cross-member. Locate the two hex head mounting bolts that attach the winch mechanism to the frame cross-member. Remove the mounting bolt located on the left rear corner of the winch mechanism. Use the mounting bolt to install the U-bracket and position as shown in the picture. Install both flat washers between the U-bracket and cross-member.
STEP THREE Raise the spare tire while
guiding the lower end of lock bar through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as spare tire is returned to the full up/stored position.
Install the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the left rear of the vehicle. Place the crimp-ring retainer in the groove and crimp closed with pliers. Rotate U-bracket until the lock bar is positioned approx. 2-3/8 inches from vertical winch cable and tighten mounting bolt.
This Lock Is Designed To Install With The Spare Tire In The Orignal Factory Position, Valve Stem Up.
SPECIAL BLACK MAX LOCKING INSTRUCTIONS:
(1) Remove key the from the lock cylinder. (2)Place the Black Max lock assembly over the end of the lock bar with the bar cover/seal end up. (3)Slide the lock assembly upward so that the cover/seal is compressed in the tapered surface of the lug hole. (4)Press in on the "Push To Lock" button with the lock assembly still held firmly against the tapered surface to engage the deadbolt lock mechanism with the groove in the lock bar.
RECORD KEY CODE NUMBER FOR FUTURE REFERENCE
Lubricate Grease Fitting Once A Year To Validate LIMITED LIFETIME CORROSION WARRANTY
DO NOT Use Lithium Base Lubricants
UNITED STATES PATENTS
4794771 - D399122 - 6505488
BACK| |MAIN PAGE