BLACK MAX SERIES - MAXIMUM SECURITY
SPARE TIRE THEFT PROTECTION
Lower spare tire for access to the winch mechanism mounted above the frame cross-member. Locate the threaded ends of three winch mechanism mounting bolts which extend down through the frame cross-member from above. Install the U-bracket over the threaded end of mounting bolt to the rear of winch cable, positioned as shown in the picture. Install the 10mm locknut and flat washer. Tighten the locknut and loosen slightly so that the U-bracket will still rotate on the mounting bolt.
STEP TWO Install the lock bar through the holes in both legs of the U-bracket, with the grooved end facing toward the right side frame rail. Install the crimp-ring retainer in the groove and crimp closed with pliers. Rotate the U-bracket until the lock bar is positioned approx. 2-3/8 inches from vertical winch cable and tighten locknut.
STEP THREE Raise the spare tire while guiding the lower end of lock bar through the lug hole least obstructed by the winch cable retaining plate in the center of the wheel. The lock bar must remain vertical as spare tire is returned to the full up/stored position.
SPECIAL BLACK MAX LOCKING INSTRUCTIONS: (1) Remove key the from the lock cylinder. (2)Place the Black Max lock assembly over the end of the lock bar with the bar cover/seal end up. (3)Slide the lock assembly upward so that the cover/seal is compressed in the tapered surface of the lug hole. (4)Press in on the "Push To Lock" button with the lock assembly still held firmly against the tapered surface to engage the deadbolt lock mechanism with the groove in the lock bar.